Collinite Fiberglass Boat Cleaner No. 920

Collinite Fiberglass Boat Cleaner restores the original color quickly without hard rubbing or buffing. It increases long-lasting brilliance and performance of your protective wax coating. Apply the 925 fiberglass boat wax or the 885 Fleetwax after the 920 has been buffed off for maximum protection.

Directions for use:

• Shake well before using.
• Apply cleaner with a microfiber towel folded into a pad, or with a microfiber applicator.
• Rub as necessary to loosen all film, discoloration, etc.
• Buff off the cleaner with a clean, dry, soft cloth.

16 fl. oz.

Helpful Hints for Using Collinite Products

No matter which Collinite products you choose to use on your watercraft, here are some guidelines to help you get the most benefit.

• The ideal temperature range for using Collinite products is between 60 and 85 degrees. Using the product when the temperature is less than 60 degrees could result in streaking or difficulty in removing the product from the finish. 
• Avoid Applying the product in direct sunlight. Try to work in the shade. The heat from the sun will accelerate the rate at which the wax sets up on your finish, and will make removing the product very difficult. Make sure the finish is approximately between 68 and 70 degrees. 
• Make sure the finish is clean and dry before applying any wax to avoid creating swirls.
• Wax in a straight line, following the pattern that air would pass over your boat. Waxing in circles could lead to swirl marks.
• Apply the product in small sections at a time, usually 2x2 or 3x3 foot areas at a time.
• Use a soft-cotton cloth for your final buffing. Turn the cloth frequently and try to buff using straight lines.